Selling your WPB condo?

Free Market Valuation →

How the Sun & Shade Analyzer Works

The analyzer computes where the sun is for an address, date and time, projects the shadows of nearby buildings onto the ground, and estimates how much of a property’s open space is in direct sun across the day. This page sets out each step, the data behind it, and what the tool does not model.

The five steps

  1. The address is geocoded to a latitude and longitude.
  2. Building footprints and pools within 300 metres are fetched from OpenStreetMap, and the parcel boundary from Palm Beach County GIS.
  3. The sun’s azimuth and elevation are computed for the chosen date and time.
  4. Each building footprint is projected away from the sun to get its ground shadow.
  5. The property’s open space is sampled across the whole day to estimate morning, afternoon and overall sun exposure.

Steps 3 to 5 run in the browser, which is why dragging the time slider redraws the map immediately.

Data sources

  • Address lookup: OpenStreetMap’s Nominatim geocoder, with the US Census geocoder as a fallback. Census results are interpolated along the street rather than placed on the rooftop, and the tool flags a result when it is interpolated.
  • Building footprints and pools: OpenStreetMap, queried through the Overpass API for a 300-metre radius around the address. The radius follows from the shadow model: with shadows capped at 500 metres, buildings much further away cannot reach the property.
  • Parcel boundaries and aerial imagery: Palm Beach County GIS.
  • Sun position: the open-source SunCalc library. No dataset is involved; it is astronomy computed from latitude, longitude and time.

Sun position

For the chosen instant the tool computes two angles. Azimuth is the compass bearing of the sun, measured clockwise from true north (0° north, 90° east, 180° south). Elevation is its height above the horizon, corrected for atmospheric refraction.

Times are the property’s local wall-clock time, converted through the time zone for its location rather than a fixed offset, so daylight saving time is handled. Sunrise, solar noon and sunset are computed for the chosen calendar date and set the range of the time slider.

Building heights

Shadow length depends on building height, and most mapped buildings carry no height information. The tool resolves a height in this order and states in its summary panel which one it used:

  1. The height recorded on the building in OpenStreetMap, where one exists.
  2. The number of floors recorded in OpenStreetMap, at 3.2 metres per floor.
  3. For the property being analysed only, where OpenStreetMap has neither: the number of storeys implied by the county’s recorded living area divided by the building’s ground footprint. This is applied only when it implies two to four storeys on a parcel with a single building.
  4. A default of 20 feet (6.1 metres), the height of a single-storey Florida house.

The shadow model

Each building is treated as a vertical prism rising from its footprint.

  • Shadow length: height ÷ tan(sun elevation)
  • Shadow direction: sun azimuth + 180°, directly away from the sun

The ground shadow is the footprint, the same footprint shifted along the shadow direction by the shadow length, and the area swept between them along every edge. That gives the true projection for L-shaped and courtyard buildings, where a simple outline would fill in the gaps.

Two limits are applied:

  • Sun below 3° elevation. Shadow length runs toward infinity as the sun nears the horizon, so below 3° no shadows are drawn and the period is treated as having no usable direct sun.
  • 500-metre maximum. No single shadow is drawn longer than 500 metres.

Exposure ratings

The High, Moderate and Low ratings are derived, not measured. The property’s open space is the parcel minus every building footprint on it. Where no parcel boundary is available, a circle of 25 metres radius around the address stands in for it.

  • The open space is sampled as a grid of up to 48 points.
  • The day is walked from sunrise to sunset in 30-minute steps.
  • At each step the shadows are recomputed and every sample point is tested for whether it falls inside one.
  • The result is the share of those point-and-time samples that are in direct sun. Morning and afternoon are divided at solar noon, not at 12:00.
Exposure rating by share of daylight in direct sun
Share of daylight in direct sunRating
70% or moreHigh
40% to under 70%Moderate
Under 40%Low

Seasonal comparison

The seasonal view runs the same exposure calculation on four dates: 20 March, 21 June, 22 September and 21 December. These are fixed calendar dates for the equinoxes and solstices, which can be a day off the astronomical event in some years. For each date it reports the sun’s elevation at solar noon, the length of the day and the exposure ratings, and the difference between the sunniest and least sunny of the four.

What it does not model

  • Trees. Only building shadows are calculated. Trees, awnings and screen enclosures are not, and in Florida a mature tree is often what actually shades a pool or patio.
  • Terrain. The ground is treated as flat.
  • Unknown heights. A building with no recorded height or floor count is modelled at 20 feet, so a neighbouring two-storey house can be drawn as one storey. Tall towers are more often recorded than houses.
  • Some building shapes. Buildings mapped in OpenStreetMap as multi-part relations, mostly courtyard blocks, are not read.
  • Individual units. A condominium tower’s parcel is the whole lot, shared by every unit, so the result describes the building’s site and envelope. It does not say which rooms or which balcony on a given floor receive sun.
  • Recent construction. A building that is not yet mapped casts no shadow in the tool, and the aerial imagery may predate it.
  • Weather. Cloud cover is not considered.

Sun and shade projections are estimates based on available mapping, building, and solar-position data. Actual conditions may vary due to trees, structures, terrain, weather, and unavailable building-height information. Building footprints © OpenStreetMap contributors. Parcel data and aerial imagery courtesy of Palm Beach County GIS.

Open the Sun & Shade Analyzer

Sell with Christine & John

Thinking of Selling Your WPB Condo?

Christine & John know your building better than any generalist agent — every closed comp, every active listing, every competing new construction project in your price range. That's how you price right the first time.

We Know These Buildings

Deep WPB condo market knowledge — we track every building, comp set, and price trend so your listing is priced right from day one.

condowpb.com Buyer Pipeline

Our site attracts active condo buyers — your listing is in front of them before we run a single ad.

Pricing Backed by Data

We track resale history and price trends for every building in the market. We price with data, not estimates.

Certified Seller Representation

John holds the SRS designation — a national credential for advanced seller representation held by fewer than 5% of agents. Both agents hold RENE.

See How We Sell WPB Condos →

2017

Team Founded

3x

Platinum Producers

43+

Buildings Tracked